Aimpoint Acro P2 Dedicated Optic Cut (Irons in Rear) for Glock

Description

This is a service to cut your factory Glock slide to allow direct mounting of an optic (aftermarket slides cut with prior approval). Factory optic ready slides cannot be cut unless specifically stated. We only offer cuts for the models listed on this page, if you have any questions or have a model not listed, please reach out [email protected]

Summary of this service:

• This is an Acro P2 specific cut; we do not guarantee fitment with other optics that use a similar footprint. This cut allows you to keep your irons to the rear of the optic.

Mounting Screws: 

We do not provide screws with this cut.

Recommended Sights for Lower 1/3 Co-witness: Due to the factory MOS slides having the dovetail further back on the slide, we need to relocate the dovetail on this cut to keep it behind the optic. Due to this the new dovetail ends up being .080″ lower and in order for irons to work properly, you need to compensate for this change by having a .080″ taller rear iron compared to a normal matched set of irons. For example if you would normally want a .310″ rear and .305″ front iron, to get the same cowitness height with this cut, you would need a .390″ rear and .305″ front.

For the Acro P2 we offer irons that give a lower 1/3 cowitness on our iron sights page.

IRON LOCATION: We only offer the rear iron dovetail location with this cut at this time.

COATINGS: Two refinishing options are available for this cut. Due to the amount of exposed metal with this cut, we do not offer the cold blue finish.  The cerakote and nitride options are for the entire slide. We use H series oven cure cerakote and offer 5 colors. The black nitride is a OEM style metal heat treatment that improves surface hardness and gives the slide higher wear resistance compared to the cerakote.  Note that nitride lead times are not guaranteed and may take 3-4 weeks.

For detailed coating descriptions, see our Coatings Explained Page: https://wagermachineworks.com/coating-options-explained/

THE PROCESS: After checkout, you will receive instructions for shipping your stripped slide to us (please remove the barrel and recoil spring unless you are also getting porting). We will perform the cut and/or refinishing and ship the slide back promptly. You will receive an email notification once we receive the slide (typically the day after it gets delivered to us) and a second email when it ships back to you with a tracking number.

TIMELINE: We will complete the work in the stated turnaround time (Mon-Fri) or less, including coating, after receiving your slide.

Note: Your order will be returned to the address provided at checkout. Follow instructions and include a copy of your confirmation email when shipping your slide to us to avoid increased turnaround time.

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.