Angry Bear Arms Sights (Free Install with Optic Cut) for Glock

Description

We offer iron sights from Angry Bear Arms, specifically designed for Glock platforms. When you order an optic cut, you receive free installation of these sights.

We currently stock blacked out iron sights, as they are preferred for use with optics. Available heights vary for Glock slides.

Single Stack Slides (G43, 43x, 48):

• Holosun 407k/507k – Optic height set recommended for lower 1/3 co-witness. Use the .200" tall set for a very low co-witness.
• Holosun EPS Models – Use the .200" tall set unless using with a suppressor; suppressor height set will be higher than lower 1/3.
• Trijicon RMRcc – Not compatible due to proximity to the iron dovetail.

MOS conversion cuts: We recommend the .200" tall set for a good lower co-witness.

Double Stack Standard Slides (G17, 19, 26, etc):

• RMR/Holosun 407c/507c – Optic height set recommended for lower 1/3 co-witness.
• SRO/RMRhd – Optic height set will provide a lower 1/4 co-witness.
• Holosun 407k/507k – Optic height set recommended for lower 1/3 co-witness; .200" tall set for very low co-witness.
• Holosun EPS – Use the .200" tall set unless using with a suppressor; optic height set will be higher than lower 1/3.
• Holosun 509t – Optic height set slightly taller than lower 1/3 co-witness; .200" tall set for very low co-witness.
• Holosun 509 ACSS – Optic height set for forward position; rear position allows for slightly taller than lower 1/3 or .200" tall set for very low co-witness.
• Trijicon RMRcc – Optic height set for lower 1/3 co-witness.
• Leupold DPP – Not compatible due to height.
• Aimpoint Acro – Optic height set provides slightly taller than lower 1/3 co-witness.

Large Frame Double Stack (G20/21/29, etc): Follow the same suggestions as standard double stack slides.

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.