Description
This is a service to cut your factory Glock slide to allow direct mounting of an optic (aftermarket slides cut with prior approval). Factory optic ready slides cannot be cut unless specifically stated. We only offer cuts for the models listed on this page, if you have any questions or have a model not listed, please reach out [email protected]
Summary of this service:
- Fits the Holosun SCS MOS as well as most MOS plates
- Same depth and location as the factory MOS slides – plates with serrations on them will line up like factory.
- Mounts with standard M3 x .5 screws (not provided)
Mounting Screws:
We do not provide screws with this cut. The Holosun SCS MOS will mount with the provided screws and MOS plates will mount with their provided screws.
Recommended Sights for Lower 1/3 Co-witness: Due to the factory MOS slides having the dovetail further back on the slide, we need to relocate the dovetail on this cut to keep it behind the optic. Due to this the new dovetail ends up being .080″ lower and in order for irons to work properly, you need to compensate for this change by having a .080″ taller rear iron compared to a normal matched set of irons. For example if you would normally want a .310″ rear and .305″ front iron, to get the same cowitness height with this cut, you would need a .390″ rear and .305″ front.
For the SCS MOS we offer irons that give a lower 1/3 cowitness on our iron sights page.
IRON LOCATION: We only offer the rear iron dovetail location with this cut at this time.
COATINGS: Two refinishing options are available for this cut. Due to the amount of exposed metal with this cut, we do not offer the cold blue finish. The cerakote and nitride options are for the entire slide. We use H series oven cure cerakote and offer 5 colors. The black nitride is a OEM style metal heat treatment that improves surface hardness and gives the slide higher wear resistance compared to the cerakote. Note that nitride lead times are not guaranteed and may take 3-4 weeks.
For detailed coating descriptions, see our Coatings Explained Page: https://wagermachineworks.com/coating-options-explained/
THE PROCESS: After checkout, you will receive instructions for shipping your stripped slide to us (please remove the barrel and recoil spring unless you are also getting porting). We will perform the cut and/or refinishing and ship the slide back promptly. You will receive an email notification once we receive the slide (typically the day after it gets delivered to us) and a second email when it ships back to you with a tracking number.
TIMELINE: We will complete the work in the stated turnaround time (Mon-Fri) or less, including coating, after receiving your slide.
Note: Your order will be returned to the address provided at checkout. Follow instructions and include a copy of your confirmation email when shipping your slide to us to avoid increased turnaround time.
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
JB –
I have had my upper back for a little over a month and have put around a thousand rounds through it with a Holosun EPS. The milling was very well done and I have had no issues whatsoever. Wager did incredible work on my Glock 19. The nitride coating looks close to factory and the optic fits like a glove.
Gill –
If you are waiting to have your slide milled, do not wait any longer. This is by far the best work I have seen in a couple of my milled slides. The cut was deeper than others without interfering with the internal components. 5 star is an understatement.
Mike –
Shipped it to Wager with a flat-rate USPS box. Sent out on Wednesday morning, they received my slide on Saturday. Work was completed and slide was sent back out by the next Wednesday. In just 10 days I had my slide cut and cerakoted. The cut is precise and fits my Holosun like a glove.